QCAD Bugtracker

  • Status Assigned
  • Percent Complete
    0%
  • Task Type Bug Report
  • Category QCAD (main)
  • Assigned To
    Andrew
  • Operating System All
  • Severity Low
  • Priority Very Low
  • Reported Version 3.4.5
  • Due in Version Undecided
  • Due Date Undecided
  • Votes
  • Private
Attached to Project: QCAD Bugtracker
Opened by William Swanson - 31.12.2013
Last edited by Andrew - 31.12.2013

FS#1002 - Move/Rotate does not remember last-used angle

Steps to reproduce:

  1. Select an entity
  2. Activate the move/rotate tool (MR)
  3. Enter some angle into the dialog box
  4. Hit OK
  5. Repeat steps 1-2
  6. Notice that the angle that was entered in step 3 is not remembered, but that the dialog box always contains the same default angle.

Expected results:

The angle entered in step 3 should be remembered between invocations of the tool, just as it is for the plain rotate tool.

William Swanson commented on 31.12.2013 20:27

I forgot to mention, this has been broken since at least 3.1.2, and maybe earlier - well over a year now.

Husky commented on 31.12.2013 20:40

XP32/3.4.5.

Hi,
it works just fine for me. No default angle and the given angle is remembered correctly ...

William Swanson commented on 31.12.2013 20:51

Ah, I see what the difference is. The version set in the toolbar is remembered, but the version set in the dialog box is not.

Loading...

Available keyboard shortcuts

Tasklist

Task Details

Task Editing