QCAD Bugtracker

  • Status Assigned
  • Percent Complete
    0%
  • Task Type Feature Request
  • Category QCAD (main)
  • Assigned To
    Andrew
  • Operating System All
  • Severity Low
  • Priority Very Low
  • Reported Version 3.4.5
  • Due in Version Undecided
  • Due Date Undecided
  • Votes
  • Private
Attached to Project: QCAD Bugtracker
Opened by Herb - 07.01.2014
Last edited by Andrew - 07.01.2014

FS#1009 - Layer Order is Alphabetical vs the Order Defined Originally

It would appear that when QCAD imports a DXF, it reorders the layers into alphabetical order (at least when importing R2011). I have not tested this extensively but on other programs, the order is different from alphabetical. Ideally the operator should be given a choice to order the layers as exported (assuming the DXF format remembers that) or alphabetical. This is because a drawing may have a certain stack up of layers (like a printed circuit board) and then alphabetic ordering is not useful nor desired.

Admin
Andrew commented on 07.01.2014 09:34

Changed into a feature request.

Please note also that layers in CAD have no connection to drawing order (just in case you were expecting this).

Loading...

Available keyboard shortcuts

Tasklist

Task Details

Task Editing