QCAD Bugtracker

  • Status Closed
  • Percent Complete
    100%
  • Task Type Bug Report
  • Category QCAD (main)
  • Assigned To
    Andrew
  • Operating System Windows XP
  • Severity Low
  • Priority Very Low
  • Reported Version 3.4.6
  • Due in Version Undecided
  • Due Date Undecided
  • Votes
  • Private
Attached to Project: QCAD Bugtracker
Opened by Husky - 11.02.2014
Last edited by Andrew - 21.01.2015

FS#1020 - Line2PEx, Option-bar for angles disregard the Decimal Point settings

My QCAD setting for “Decimal Points” is “dot” instead of “comma”.
(Application Preferences, General, Coordinate Format, Decimal Point: Dot ‘.’(Default))

The new Line2PEx tool will only accept a comma - if I use a dot it will be automatically replaced by a comma.
The displayed angle in the drawing will use a dot.
No red Text font warning for using an invalid value.

I used a screen-shot with an additional coordinate option to make it a bit clearer:

Closed by  Andrew
21.01.2015 00:28
Reason for closing:  Won't fix
Additional comments about closing:  

features have been ported to the standard line tool

-- commented on 12.02.2014 10:12

After testing I find i have the opposite problem.
On my system at work (windows vista) I can only use 'Dot', which for me is fine - but changing to Comma doesn't work if I needed to!

Admin
Andrew commented on 12.02.2014 10:15

I think the spin box should probably be changed into a RMathLineEdit instead. This would also allow for formulas to be entered.
I've also posted this to the forum for riverbuoy:
http://qcad.org/rsforum/viewtopic.php?f=107&t=2760&p=9515#p9515

Loading...

Available keyboard shortcuts

Tasklist

Task Details

Task Editing