- Status Closed
- Percent Complete
- Task Type Bug Report
- Category QCAD (main)
-
Assigned To
Andrew - Operating System Windows XP
- Severity Low
- Priority Very Low
- Reported Version 3.4.6
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
Attached to Project: QCAD Bugtracker
Opened by Husky - 11.02.2014
Last edited by Andrew - 21.01.2015
Opened by Husky - 11.02.2014
Last edited by Andrew - 21.01.2015
FS#1020 - Line2PEx, Option-bar for angles disregard the Decimal Point settings
My QCAD setting for “Decimal Points” is “dot” instead of “comma”.
(Application Preferences, General, Coordinate Format, Decimal Point: Dot ‘.’(Default))
The new Line2PEx tool will only accept a comma - if I use a dot it will be automatically replaced by a comma.
The displayed angle in the drawing will use a dot.
No red Text font warning for using an invalid value.
I used a screen-shot with an additional coordinate option to make it a bit clearer:
Closed by Andrew
21.01.2015 00:28
Reason for closing: Won't fix
Additional comments about closing:
21.01.2015 00:28
Reason for closing: Won't fix
Additional comments about closing:
features have been ported to the
standard line tool
After testing I find i have the opposite problem.
On my system at work (windows vista) I can only use 'Dot', which for me is fine - but changing to Comma doesn't work if I needed to!
I think the spin box should probably be changed into a RMathLineEdit instead. This would also allow for formulas to be entered.
I've also posted this to the forum for riverbuoy:
http://qcad.org/rsforum/viewtopic.php?f=107&t=2760&p=9515#p9515