- Status Closed
- Percent Complete
- Task Type Feature Request
- Category QCAD (main)
-
Assigned To
Andrew - Operating System All
- Severity Low
- Priority Very Low
- Reported Version 3.5.1
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
Opened by Craig McKie - 13.06.2014
Last edited by Andrew - 17.11.2015
FS#1061 - Polygonal / Rectangular Marquee Tool ?
Defining hatch areas at present is time consuming as you have to create an additional layer and amend as necessary to create a boundary. What would speed up this process is a multi function tool to create a closed boundary line that could be used for fills and hatches or to delete specific areas from a drawing. This tool could have the following sub menu:
* Polygonal Selection
* Rectangular Selection (Use with modifier key to keep square)
* Circular / Oval Selection (Use with modifier key to keep round)
Each tool could have the following options:
1. New selection
2. Add to selection
3. Delete from selection
4. Intersect with selection
This tool would be invaluable for speeding up work-flow, simple actions like trimming lines could be achieved with a simple selection and backspace to delete etc. Please give this some consideration, this could be a great amendment to QCAD !
17.11.2015 09:18
Reason for closing: Implemented
Additional comments about closing:
Selection modes have been implemented in
QCAD 3.4.4.
Circular / oval
selection has not been implemented.