- Status Closed
- Percent Complete
- Task Type Bug Report
- Category QCAD (main)
-
Assigned To
Andrew - Operating System All
- Severity Low
- Priority Very Low
- Reported Version 3.6.2
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
Attached to Project: QCAD Bugtracker
Opened by Husky - 23.07.2014
Last edited by Andrew - 09.02.2016
Opened by Husky - 23.07.2014
Last edited by Andrew - 09.02.2016
FS#1077 - Centreline Cross using wrong Coordinate Format
My Coordinate Format/Decimal Point is adjusted to Dot’.’ but the “Centreline Cross (C,S)” will only accept Comma for Angel. X/Y works fine!
BTW: Is the spelling correct in the Menu? Should it be spelled “Centerline Cross” instead of “Centreline Cross” ...?
Closed by Andrew
09.02.2016 13:46
Reason for closing: Fixed
Additional comments about closing:
09.02.2016 13:46
Reason for closing: Fixed
Additional comments about closing:
fixed by replacing double spin control
with line edit
https://github.com/qcad/qcad/commit
/f201f42802dcbcea36ed9ab5684ae12b1973fda
2