QCAD Bugtracker

  • Status Assigned
  • Percent Complete
    0%
  • Task Type Feature Request
  • Category QCAD (main)
  • Assigned To
    Andrew
  • Operating System All
  • Severity Low
  • Priority Very Low
  • Reported Version 3.6.3
  • Due in Version Undecided
  • Due Date Undecided
  • Votes 2
  • Private
Attached to Project: QCAD Bugtracker
Opened by V. Oth - 22.08.2014

FS#1090 - Export only selected layers to SVG and/or export each layer to a separate SVG

When exporting to SVG it would be helpful if there was a selection of layers to export.
E.g. when selecting only layer A in the SVG export dialog, only the objects located/displayed on layer A would be exported to SVG.

As an alternative or additional export feature, there could be an option to export each (non-empty) layer to a separate SVG in one step.
The layer names could be used as (part of the) default file names during the export.
E.g. Layer A of file XYZ would be exported to “XYZ_A.SVG” while layer B would be exported to “XYZ_B.SVG” etc.

Soma Somodi commented on 14.11.2018 18:28

Furthermore, it would be useful if I can select a variant (of layers, set by user) in the svg export popup, so I do not have to make the selection next time I do the export. Or just remember the last used selection until the program runs.

BJ Stigall commented on 12.11.2022 03:22

It would be good to have an option to only export visible layers.

Loading...

Available keyboard shortcuts

Tasklist

Task Details

Task Editing