QCAD Bugtracker

  • Status Assigned
  • Percent Complete
    0%
  • Task Type Feature Request
  • Category QCAD (main)
  • Assigned To
    Andrew
  • Operating System All
  • Severity Low
  • Priority Very Low
  • Reported Version Development
  • Due in Version Undecided
  • Due Date Undecided
  • Votes
  • Private
Attached to Project: QCAD Bugtracker
Opened by Anonymous Submitter - 26.11.2014

FS#1130 - Offset Polyline from both sides at once

It would be great to have a tick box to be able to offset a polyline from both sides/edges at once.

Maybe a similar feature could be added to the line -parallel tools?

CVH commented on 29.10.2022 07:30

Offset both sides of an open Polyline/Spline is implemented under Misc .. Modify.
Depending on the indicated position there is even an semi-circle added at the ends.
The Preview for Splines may be off but the result is fine.

It seems there is only one offset for Lines-Arcs-Circles-Ellipses ...
It seems that it offsets text entities very partially ...
There may be many 'Result loop not closed' or 'No offsets possible' warnings ...

Also see: FS#2415

Regards,
CVH

Loading...

Available keyboard shortcuts

Tasklist

Task Details

Task Editing