- Status Closed
- Percent Complete
- Task Type Bug Report
- Category QCAD (main)
-
Assigned To
Andrew - Operating System All
- Severity Low
- Priority Very Low
- Reported Version 3.9.4
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
FS#1225 - add support for circles, ellipses
The attached file should result in two overlapping circles, it does not, it results in a single ellipse.
The “<circle ... />” directive seems just be ignored in this case, but in other instances I have seen it result in ellipses.
And the “<ellipse ... />” directive should of course result in a circle, when rx and ry are the same.
ellipse_bug.svg