QCAD Bugtracker

  • Status Assigned
  • Percent Complete
    0%
  • Task Type Feature Request
  • Category QCAD (main)
  • Assigned To
    Andrew
  • Operating System All
  • Severity Low
  • Priority Very Low
  • Reported Version 3.10.0
  • Due in Version Undecided
  • Due Date Undecided
  • Votes
  • Private
Attached to Project: QCAD Bugtracker
Opened by lalebarde - 28.08.2015

FS#1254 - Add drop object along a path with automatic trim

Add drop object along a path with automatic trim.

  1. The object can be a selection before or after selecting the tool, an entity or a block.
  1. The path can be another entity from a start point to an end point.
  1. Dropping can be made on one side or the other (like in other tools depending on the side of the cursor), with a choice of miroring the object or not.
  1. The number of drops or the distance between can be selected.
  1. The distance can be between a control point of the object or its sysmetry axis or border.
  1. The dropping direction can be selected too.
  1. The droping depth can be constrained : all control points have passed the path, or one of them. Alternatively, replace control points by an entity belonging to the object.

Exemple of use case : equidistant drills in a curved rail. The dropping depth constraint enables for example to ensure a drill has a minimal depth when not orthogonal to a plan.

lalebarde commented on 28.08.2015 12:44

The example drawing was missing (attached)

Loading...

Available keyboard shortcuts

Tasklist

Task Details

Task Editing