- Status Closed
- Percent Complete
- Task Type Bug Report
- Category QCAD (main)
-
Assigned To
Andrew - Operating System All
- Severity Low
- Priority Very Low
- Reported Version 3.12.1
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
Attached to Project: QCAD Bugtracker
Opened by H Stiekema - 18.11.2015
Last edited by Andrew - 18.11.2015
Opened by H Stiekema - 18.11.2015
Last edited by Andrew - 18.11.2015
FS#1299 - Incorrect printing scale behaviour
In Printpreview. Scaling the print does not scale the drawing smaller, but the paper -size larger. This is unexpected.
One should scale the drawing down to available paper size, not the other way.
Scaling is not done at the natural intuitive analog manner, with surprising results.
When scaling, all visible attributes becomes smaller; lineweigth too
See added pdf.
Closed by Andrew
18.11.2015 10:47
Reason for closing: Not a bug
Additional comments about closing:
18.11.2015 10:47
Reason for closing: Not a bug
Additional comments about closing:
This is expected behavior.
The
scale factor does NOT scale or otherwise
modify your drawing.
Lineweights
are defined in paper units (1mm line is
always printed as 1mm on paper) not
drawing units.