- Status Closed
- Percent Complete
- Task Type Bug Report
- Category QCAD (main)
-
Assigned To
Andrew - Operating System All
- Severity Low
- Priority Very Low
- Reported Version 3.12.4
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
Attached to Project: QCAD Bugtracker
Opened by Thomas Stoelting - 19.12.2015
Last edited by Andrew - 19.12.2015
Opened by Thomas Stoelting - 19.12.2015
Last edited by Andrew - 19.12.2015
FS#1336 - Wrong snap points on circle
When you draw a line to a circle the offered snap points (orthogonal, tangential ...) are ok.
But if you change a line by moving an end- or startpoint qcad gives you snap points corresponding to the opposite endpoint of the line.