- Status Assigned
- Percent Complete
- Task Type Feature Request
- Category QCAD (main)
-
Assigned To
Andrew - Operating System All
- Severity Low
- Priority Very Low
- Reported Version 3.12.5
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
FS#1363 - New Tool - make lines horizontal or vertical
New Tool Request:
To have a tool to make any given line which is ‘not’ orthogonal already into an orthogonal line.
For example if I had a line at 30 degrees by using the tool I could change the line to be either horizontal or vertical.
Simply a question of setting the line angle to 0-90-180-270 degrees.
Or that of a selection of line segments.
IMHO such tools are only used by a few and may saturate the GUI with unused features.
I would decline this request.
Regards,
CVH