QCAD Bugtracker

  • Status Assigned
  • Percent Complete
    0%
  • Task Type Feature Request
  • Category QCAD (main)
  • Assigned To
    Andrew
  • Operating System All
  • Severity Low
  • Priority Very Low
  • Reported Version 3.12.6
  • Due in Version Undecided
  • Due Date Undecided
  • Votes 2
  • Private
Attached to Project: QCAD Bugtracker
Opened by Anonymous Submitter - 28.01.2016

FS#1364 - New Tool -'Run Parallel with'

New Tool request:

When drawing a line it would be good to have a tool/option to ‘run parallel with’.

For example start to draw a line and choose ‘run parallel with’, select appropriate line to draw parallel with!

Andreas commented on 28.08.2016 10:31

Whould be a nice feature!

CVH commented on 30.10.2022 07:35

I can see the benefits of this.
This might be useful to skip a Parallel Trough point and then extending and/or trimming it.

The sequence is then:
- Pick startpoint.
- Pick the appropriate line to draw parallel with.
- Indicate the endpoint as if it was a Ray.

Voted for it. ;-)

Regards,
CVH

Loading...

Available keyboard shortcuts

Tasklist

Task Details

Task Editing