- Status Closed
- Percent Complete
- Task Type Bug Report
- Category QCAD (main)
-
Assigned To
Andrew - Operating System All
- Severity Low
- Priority Very Low
- Reported Version 3.14.2
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
Attached to Project: QCAD Bugtracker
Opened by Andrew - 28.04.2016
Last edited by Andrew - 28.04.2016
Opened by Andrew - 28.04.2016
Last edited by Andrew - 28.04.2016
FS#1416 - Dimension value for drawing unit feet
If the drawing unit is set to ‘feet’ and the dimension format is ‘architectural’ or ‘engineering’, the drawing unit should be implicitly regarded as inch for the purpose of calculating dimension values. Since QCAD uses the drawing unit, the dimension values are off by a factor of 12 when importing drawings from other products.
Closed by Andrew
28.04.2016 08:12
Reason for closing: Fixed
Additional comments about closing:
28.04.2016 08:12
Reason for closing: Fixed
Additional comments about closing:
https://github.com/qcad/qcad/commit /d698aa7c2588175ee5e64ff0adcfdc762782524 1