- Status Closed
- Percent Complete
- Task Type Bug Report
- Category QCAD (main)
-
Assigned To
Andrew - Operating System Linux (All / Other)
- Severity Low
- Priority Very Low
- Reported Version 3.16.4
- Due in Version Undecided
-
Due Date
Undecided
-
Votes
1
- Christian Aigner (12.01.2017)
- Private
Attached to Project: QCAD Bugtracker
Opened by Christian Aigner - 12.01.2017
Last edited by Andrew - 01.02.2017
Opened by Christian Aigner - 12.01.2017
Last edited by Andrew - 01.02.2017
FS#1530 - Draw > Circle > 3 Tangents: solutions not found
Given is a drawing of two concentric arcs connected at the ends. (see attached drawing Circle_from_3_Tangents_1.png)
When I try to add a circle at one end by the “Circle from 3 Tangents”-tool, it does nothing.
I also tried it with another drawing (see attached drawing Circle_from_3_Tangents_2.png) - same negative result.
I then tried drawing Circle_from_3_Tangents_3.png. Here the tool only produces outside circles and misses the inside ones.
Hope you can confirm my findings.
Closed by Andrew
01.02.2017 09:31
Reason for closing: Fixed
Additional comments about closing:
01.02.2017 09:31
Reason for closing: Fixed
Additional comments about closing:
https://github.com/qcad/qcad/commit /d747a4f4f0826d242d834b87e10cdb94f527d09 d
I tested the new Apollonius.js and it works now for my first example, but with exampe #2 and #3 the problem still exists.