- Status Closed
- Percent Complete
- Task Type Bug Report
- Category QCAD (main)
-
Assigned To
Andrew - Operating System All
- Severity Low
- Priority Very Low
- Reported Version 3.16.5
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
Attached to Project: QCAD Bugtracker
Opened by Anonymous Submitter - 21.02.2017
Last edited by Andrew - 31.03.2017
Opened by Anonymous Submitter - 21.02.2017
Last edited by Andrew - 31.03.2017
FS#1547 - PDF won't print out properly
Hi Andrew
I have attached a file which was drawn in QCAD, but for some reason when exported to PDF from QCAD it doesn’t print out properly,all I get is the dimensions only.
When printed direct from QCAD all is fine?
Regards
Clive
Closed by Andrew
31.03.2017 21:37
Reason for closing: Won't fix
Additional comments about closing:
31.03.2017 21:37
Reason for closing: Won't fix
Additional comments about closing:
Cannot reproduce. Please re-open and
provide file(s) if the error occurs
again.
Just sent opened this file with AutoCAD and exported to PDF from there and the resulting PDF prints out just fine, so at this stage I would say the problem is with QCAD.
The error report from the printer says -
ERROR: undefinedresult
Offending command: itransform
Stack
6773.1
4779.1
I have tried to print this to more than one computer and I get the same result.
I cannot reproduce this problem here.
Could you attach your PDF file as well?
Although, I don't think this is something that could be fixed on our end. PDF export is handled by Qt (File > PDF Export) or the installed printer driver (File > Print > Save as PDF or similar).