- Status Closed
- Percent Complete
- Task Type Bug Report
- Category QCAD (main)
-
Assigned To
Andrew - Operating System OpenSUSE Linux
- Severity Low
- Priority Very Low
- Reported Version 3.16.7
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
Attached to Project: QCAD Bugtracker
Opened by Rob Kramer - 28.03.2017
Last edited by Andrew - 28.03.2017
Opened by Rob Kramer - 28.03.2017
Last edited by Andrew - 28.03.2017
FS#1565 - Disappearing blocks.
Blocks disappear (or their content does) after creating again with the same name. In attached file:
1) Created cirle
2) Select circle, BC, select center, name is ‘testblock’ 3) Repeat 2) – circle is now gone
Thanks for your report.
You are creating a recursive block (a block that contains a block reference, referencing the same block).
Recursive blocks cannot be displayed since that would take an infinite amount of time and memory.
I will close this report. If you still have a question about blocks, please post to the forum at:
https://www.qcad.org/rsforum/viewforum.php?f=32