QCAD Bugtracker

  • Status Closed
  • Percent Complete
    100%
  • Task Type Bug Report
  • Category QCAD (main)
  • Assigned To
    Andrew
  • Operating System OpenSUSE Linux
  • Severity Low
  • Priority Very Low
  • Reported Version 3.16.7
  • Due in Version Undecided
  • Due Date Undecided
  • Votes
  • Private
Attached to Project: QCAD Bugtracker
Opened by Rob Kramer - 28.03.2017
Last edited by Andrew - 28.03.2017

FS#1565 - Disappearing blocks.

Blocks disappear (or their content does) after creating again with the same name. In attached file:

1) Created cirle
2) Select circle, BC, select center, name is ‘testblock’ 3) Repeat 2) – circle is now gone

   testblock.dxf (99.2 KiB)
Closed by  Andrew
28.03.2017 12:43
Reason for closing:  Not a bug
Admin
Andrew commented on 28.03.2017 12:43

Thanks for your report.

You are creating a recursive block (a block that contains a block reference, referencing the same block).
Recursive blocks cannot be displayed since that would take an infinite amount of time and memory.

I will close this report. If you still have a question about blocks, please post to the forum at:
https://www.qcad.org/rsforum/viewforum.php?f=32

Loading...

Available keyboard shortcuts

Tasklist

Task Details

Task Editing