QCAD Bugtracker

  • Status Assigned
  • Percent Complete
    0%
  • Task Type Suggestion
  • Category QCAD (main)
  • Assigned To
    Andrew
  • Operating System All
  • Severity Very Low
  • Priority Very Low
  • Reported Version 3.20.1
  • Due in Version Undecided
  • Due Date Undecided
  • Votes
  • Private
Attached to Project: QCAD Bugtracker
Opened by CVH - 19.05.2018
Last edited by Andrew - 20.05.2018

FS#1759 - Modify // .... selection of entities on locked layer allowed

Without any selection.
Entities on a locked layer can be selected after choosing:

Asumed wrong
- Modify DI
- Modify
B2
- Modify D3
- Modify
MT

Questionable
- Modify RM
- Modify
CH
- Modify RN Less severe
- Modify
OF
- Modify OH
- Modify
SS

Regards

21.05.2018 : A task closure has been requested. Reason for request: Not served with the degration to 'Suggestion'. Demanded closing FS#1759 & re-entered as FS#1762
CVH commented on 19.05.2018 21:09

list of 3 groups
should be read as:

....
- Modify RN

Less severe
- Modify OF
....

Admin
Andrew commented on 19.05.2018 21:27

Selection is allowed, but the entities on locked layers are not modified, can you confirm?

CVH commented on 19.05.2018 21:44

I confirm.
its only a selection issue if it is an issue at all.
Not all the modify ... functions have this behaviour.

CVH commented on 21.05.2018 09:10

Not served with the degration to 'Suggestion'.
Demanded closing FS#1759 & re-entered as FS#1762

Loading...

Available keyboard shortcuts

Tasklist

Task Details

Task Editing