QCAD Bugtracker

  • Status Waiting on User
  • Percent Complete
  • Task Type Bug Report
  • Category QCAD/CAM
  • Assigned To
  • Operating System All
  • Severity Low
  • Priority Very Low
  • Reported Version 3.21.3
  • Due in Version Undecided
  • Due Date Undecided
  • Votes
  • Private
Attached to Project: QCAD Bugtracker
Opened by Arno Humbet - 07.11.2018
Last edited by Andrew - 07.11.2018

FS#1816 - TAB function in CAM module fails

When using (adding a TAB on a radius fails).


When length of the TAB is set to 1 mm.

After export to *.nc code the code is not ok.

And then check this is NC viewer or gcode sender the length is not set to 1 mm but is smaller.

On a line this function (TAB) is correct working.

Andrew commented on 07.11.2018 10:37

Please attach your drawing file (DXF), thanks.


Available keyboard shortcuts


Task Details

Task Editing