QCAD Bugtracker

  • Status Closed
  • Percent Complete
    100%
  • Task Type Feature Request
  • Category QCAD (main)
  • Assigned To
    Andrew
  • Operating System All
  • Severity Medium
  • Priority Very Low
  • Reported Version Development
  • Due in Version Undecided
  • Due Date Undecided
  • Votes 9
  • Private
Attached to Project: QCAD Bugtracker
Opened by Andrew - 14.09.2011
Last edited by Andrew - 01.10.2018

FS#260 - Reference dimensioning

Reference dimensioning (baseline dimensioning)

Create multiple dimensions using the same base line.

Closed by  Andrew
01.10.2018 13:53
Reason for closing:  Implemented
Guy commented on 12.02.2014 17:07

What does that mean ?

Mathieu commented on 11.06.2015 19:57

I don't understand too...

Michael Gilligan commented on 13.12.2015 15:00

To answer the two previous comments:

In "baseline dimensioning" a set of dimensions are all calculated/stated as distances from a single origin, instead of from each-other.
This can be a useful way of avoiding "tolerance build-up" ... Think of a row of holes, supposedly 20mm apart; and compare the accuracy of positioning with a tolerance of [say] +/- 0.5mm ... The tenth hole could be out-of-position by 5mm if they are dimensioned from each other, but only by 0.5mm if individually dimensioned from a common baseline.

Hope that helps
MichaelG.

Loading...

Available keyboard shortcuts

Tasklist

Task Details

Task Editing