- Status Closed
- Percent Complete
- Task Type Bug Report
- Category QCAD (main)
-
Assigned To
Andrew - Operating System OpenSUSE Linux
- Severity Medium
- Priority Very Low
- Reported Version 3 Beta 3
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
Attached to Project: QCAD Bugtracker
Opened by Anonymous Submitter - 28.10.2011
Last edited by Andrew - 28.10.2011
Opened by Anonymous Submitter - 28.10.2011
Last edited by Andrew - 28.10.2011
FS#338 - PDF export generates an empty document
- simple drawing: 1 rectangle, 1 circle
- File → Export PDF
→ generates an empty document (or maybe both the lines and the background is white)
Note: After the export ones stays in print preview mode, which is a bit confusing if the command was invoked from the “normal” drawing mode.
Most likely the page size has not been configured correctly for that drawing (0x0cm).
the .conf file
set the entity color to black → same result
the generated PDF is a tiny 1 x 1 mm square
actually 0x0 most likely: