- Status Closed
- Percent Complete
- Task Type Bug Report
- Category QCAD (main)
-
Assigned To
Andrew - Operating System All
- Severity Low
- Priority Defer
- Reported Version 3 Beta 3
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
Attached to Project: QCAD Bugtracker
Opened by Anonymous Submitter - 28.10.2011
Last edited by Andrew - 30.10.2011
Opened by Anonymous Submitter - 28.10.2011
Last edited by Andrew - 30.10.2011
FS#345 - unit foot: no dotted line
can’t make a dotted line on a drawing with unit foot.
- drawing unit: foot (length taken from a actual architecture plan)
- layer settings: as shown in the screen shot
- selected line is on layer “dotted”
- line types is shown as continues for almost everything
dot_foot.png
floor plan.dwg
This has to be adjusted with the line type scaling factor if required.