QCAD - 2D CAD System.
Click here for a documentation of the DokuWiki formatting syntax that can be used in reports
Please search for existing tasks (also closed ones) before opening a new task.
Please make sure that you are using the latest Version of QCAD before posting a bug (menu Help - Check for Updates)
FS#410 - Grid preferred before enteties
Attached to Project:
QCAD
Opened by Ralf Braumann (LuxRalf) - Tuesday, 29 November 2011, 19:37 GMT+2
Last edited by Andrew (andrew) - Tuesday, 29 November 2011, 21:26 GMT+2
Opened by Ralf Braumann (LuxRalf) - Tuesday, 29 November 2011, 19:37 GMT+2
Last edited by Andrew (andrew) - Tuesday, 29 November 2011, 21:26 GMT+2
|
Details
When I want to select in example a intersection or a endpoint, QCAD v3RC2 preferred to choose the grid not the intersection or the endpoint of enteties. |
This task depends upon
Closed by Andrew (andrew)
Tuesday, 29 November 2011, 21:26 GMT+2
Reason for closing: Fixed
Additional comments about closing: r19864
Tuesday, 29 November 2011, 21:26 GMT+2
Reason for closing: Fixed
Additional comments about closing: r19864
Hi LuxRalf
I haven`t found that happening in RC2 yet! But when presented with the snap options you should be able to select the snap mode of your choice.
Regards
Clive
Hi LuxRalf
Sorry - what I meant was that if you find this happening its probably because the last snap choice is remembered, so what you do is choose the snap mode of your choice. I hope this makes sense to you!
Clive
I can confirm the bug.
It happens if auto snap is on and a grid point is closer to the mouse cursor that an intersection point but both points are within the snap range. This is caused by an optimization introduced in RC2 and will be fixed in RC3.
Click "snap" → "Auto" one time and all is good for the moment. But at the next choice it is "snapping" the grid again.
When you fix it in RC3 all is OK