- Status Closed
- Percent Complete
- Task Type Bug Report
- Category QCAD (main)
-
Assigned To
Andrew - Operating System All
- Severity Low
- Priority Very Low
- Reported Version 3 RC3
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
Attached to Project: QCAD Bugtracker
Opened by Dave Macfarlane - 01.01.2012
Last edited by Andrew - 27.02.2012
Opened by Dave Macfarlane - 01.01.2012
Last edited by Andrew - 27.02.2012
FS#446 - Polyline Offset ("Equidistant" in QCAD2) malfunctions depending on shape
Polyline/Offset tool sometimes does not generate equidistant polyline(s) correctly. Often, not always, only affects generation of the equidistant polyline(s) on ONE side of the original. A necessary condition to reproduce bug seems to be a polyline that contains a mixture of acute and obtuse angles between segments; number of segments, and whether figure is closed or not, also seem to affect appearance of bug. I have observed same behaviour in QCAD3 RC3 under Windowxs XP, and RC2 under Linux.
Closed by Andrew
27.02.2012 15:38
Reason for closing: Fixed
Additional comments about closing:
27.02.2012 15:38
Reason for closing: Fixed
Additional comments about closing:
r21132