- Status Closed
- Percent Complete
- Task Type Bug Report
- Category QCAD (main)
-
Assigned To
Andrew - Operating System All
- Severity Medium
- Priority Very Low
- Reported Version 3 RC2
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
Opened by james a r brown - 14.01.2012
Last edited by Andrew - 17.01.2012
FS#461 - QCAD3 rc2 Opening DXF Created by 2.2.2 Block Position Issues
When opening a DXF created by 2.2.2 the block entities are sometimes not being drawn in correct position and orientation.
The following is seen on the console (Which I think is related)
Debug: importing entities in block ' “Sw1pwo” '
Warning: RDwgBlockReferenceImporter::import: block reference references invalid block: “*X15”
and also (which is probably not related)
Debug: importing entities in block ' “A$C6329746C” '
Warning: RSpline::updateFromControlPoints: not enough control points: 0
Warning: RSpline::getExploded: invalid spline
Debug: RSpline: knotVector ignored
Debug: RSpline: knots: 11
Debug: RSpline: order: 4
Debug: RSpline: controlPoints: 7
Warning: RSpline::updateFromControlPoints: not enough control points: 0
Warning: RSpline::getExploded: invalid spline
Debug: RSpline: knotVector ignored
Debug: RSpline: knots: 11
Debug: RSpline: order: 4
Debug: RSpline: controlPoints: 7
Drawing file shown.
This could be a bug in 2.2.2, but it would be nice to ensure 3 can pull in old drawings without us having to rework them all.
Any questions james at enrogen dot com.
James
17.01.2012 23:04
Reason for closing: Fixed
Additional comments about closing:
r20420