- Status Closed
- Percent Complete
- Task Type Bug Report
- Category QCAD (main)
-
Assigned To
Andrew - Operating System Ubuntu Linux
- Severity Low
- Priority Very Low
- Reported Version 3 RC3
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
Attached to Project: QCAD Bugtracker
Opened by Stefan - 18.01.2012
Last edited by Andrew - 18.01.2012
Opened by Stefan - 18.01.2012
Last edited by Andrew - 18.01.2012
FS#468 - hatch not existing after save+reopen
After several hints (see IDs 464 and 465) I removed all non-zero Z-coordinates inside a dxf, so hatches seem to work even with pattern now. But after save and re-open, the hatch is not existing anymore (even with select all).
attached: screen recording
I can reproduce that bug in QCAD 3 RC2/3 but not in the current development version.
bug is closed already, but perhaps this clarifies though: saving file with QCad3 and opening with QCad2 shows the correct hatch