QCAD Bugtracker

  • Status Closed
  • Percent Complete
    100%
  • Task Type Bug Report
  • Category QCAD (main)
  • Assigned To
    Andrew
  • Operating System Ubuntu Linux
  • Severity Low
  • Priority Very Low
  • Reported Version 3 RC3
  • Due in Version Undecided
  • Due Date Undecided
  • Votes
  • Private
Attached to Project: QCAD Bugtracker
Opened by Stefan - 18.01.2012
Last edited by Andrew - 18.01.2012

FS#468 - hatch not existing after save+reopen

After several hints (see IDs 464 and 465) I removed all non-zero Z-coordinates inside a dxf, so hatches seem to work even with pattern now. But after save and re-open, the hatch is not existing anymore (even with select all).

Closed by  Andrew
18.01.2012 20:27
Reason for closing:  Fixed
Stefan commented on 18.01.2012 20:18

attached: screen recording

   out.ogv (1.06 MiB)
Admin
Andrew commented on 18.01.2012 20:27

I can reproduce that bug in QCAD 3 RC2/3 but not in the current development version.

Stefan commented on 24.01.2012 19:24

bug is closed already, but perhaps this clarifies though: saving file with QCad3 and opening with QCad2 shows the correct hatch

Loading...

Available keyboard shortcuts

Tasklist

Task Details

Task Editing