- Status Closed
- Percent Complete
- Task Type Bug Report
- Category QCAD (main)
-
Assigned To
Andrew - Operating System All
- Severity Low
- Priority Very Low
- Reported Version 3 RC3
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
Attached to Project: QCAD Bugtracker
Opened by Peter - 28.01.2012
Last edited by Andrew - 06.02.2012
Opened by Peter - 28.01.2012
Last edited by Andrew - 06.02.2012
FS#476 - Stretching dimension
Draw a horizontal dimension. Stretch (S S) it. The label remains in place. It should instead go to the new center. (Unless it was manually positioned perhaps...)
Workaround: Pick one extension and drop it to where it was, label gets centered.
Not reproducible with QCAD 3 RC3, Windows 7.
Could this only be the case for drawings imported from QCAD 2?
I now realise, that this only happens with one single drawing. Maybe I have done something stupid. Please close.