QCAD Bugtracker

  • Status Assigned
  • Percent Complete
    0%
  • Task Type Feature Request
  • Category QCAD (main)
  • Assigned To
    Andrew
  • Operating System All
  • Severity Low
  • Priority Very Low
  • Reported Version 3 RC3
  • Due in Version Undecided
  • Due Date Undecided
  • Votes 1
    • CVH (13.05.2018)
  • Private
Attached to Project: QCAD Bugtracker
Opened by Peter - 29.02.2012

FS#512 - Modify stretch and Restrict ortho

The modify stretch tool wants first and second corner, start and end point, then starts afresh. When I turn on restrict horizontally eg to align two points between start and end, the restriction sticks and I have to call restrict none, to be able to perform the next iteration, set the first corner then.

So, in the quest for a comfortable user interface, it was nice, if the modify stretch first/second corners parameter setting was not affected by current restrict/ortho etc. settings. Actually, that does not make any sense at all anyways, does it, a rectangle is defined by two degrees of freedom, isnt it?

CVH commented on 14.05.2018 07:23

It does not make sense indeed.
IMHO

Loading...

Available keyboard shortcuts

Tasklist

Task Details

Task Editing