- Status Assigned
- Percent Complete
- Task Type Feature Request
- Category QCAD (main)
-
Assigned To
Andrew - Operating System All
- Severity Low
- Priority Very Low
- Reported Version 3 RC3
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
FS#512 - Modify stretch and Restrict ortho
The modify stretch tool wants first and second corner, start and end point, then starts afresh. When I turn on restrict horizontally eg to align two points between start and end, the restriction sticks and I have to call restrict none, to be able to perform the next iteration, set the first corner then.
So, in the quest for a comfortable user interface, it was nice, if the modify stretch first/second corners parameter setting was not affected by current restrict/ortho etc. settings. Actually, that does not make any sense at all anyways, does it, a rectangle is defined by two degrees of freedom, isnt it?