QCAD Bugtracker

  • Status Closed
  • Percent Complete
    100%
  • Task Type Bug Report
  • Category QCAD (main)
  • Assigned To
    Andrew
  • Operating System Ubuntu Linux
  • Severity Low
  • Priority Very Low
  • Reported Version 3 RC5
  • Due in Version Undecided
  • Due Date Undecided
  • Votes
  • Private
Attached to Project: QCAD Bugtracker
Opened by Stefan - 12.04.2012
Last edited by Andrew - 16.12.2013

FS#544 - Hatch not restored correctly in undo operation after scale

Scaling some entities including hatches and undo-ing this, the hatches are not restored correctly (still existing, but completely malformed).

Closed by  Andrew
16.12.2013 13:25
Reason for closing:  Fixed
Additional comments about closing:  

This has been fixed in QCAD 3.1.5

Admin
Andrew commented on 25.04.2012 17:53

This happens likely after a scale operation with different X / Y factors and has to do with arcs not being scalable disproportionally (they would have to be changed into ellipses which is not implemented yet).

TODO:
The best solution for now might be to disable disproportional scaling for hatches with arc / ellipse segments.

Stefan commented on 26.04.2012 17:29

Thank you for the response, but I didn't had disproportional scaling enabled.

Loading...

Available keyboard shortcuts

Tasklist

Task Details

Task Editing