- Status Closed
- Percent Complete
- Task Type Feature Request
- Category QCAD (main)
-
Assigned To
Andrew - Operating System All
- Severity Low
- Priority Very Low
- Reported Version 3 RC5
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
Attached to Project: QCAD Bugtracker
Opened by Husky - 09.05.2012
Last edited by Andrew - 25.04.2018
Opened by Husky - 09.05.2012
Last edited by Andrew - 25.04.2018
FS#592 - Kreis Punktfunktion erweitern auf Elemente ...
Es wäre schön wenn ich einen Kreis zwischen Elemente platzieren könnte indem ich die Begrenzung nicht durch Punkte sondern durch Elemente angeben könnte. Eine Auswahl von 2-3 Elementen mit/ohne Radius soll den Kreis Geometrisch korrekt an die Begrenzungselemente anschließen lassen.
Hilfskonstruktionen oder der Umweg über Round RN (was allerdings nur bei geraden Linien funktionieren kann) würden dadurch entfallen.
Laienhaft könnte ich mir vorstellen das die Grundlage für diese Funktion bereits in der Round (RN) Funktion existiert ...
Husky - yes agreed, I would like to vote for this too.I have added a similar request here:
http://www.ribbonsoft.com/bugtracker/index.php?do=details&task_id=366&project=1&pagenum=4
For me to start with, having - Tan,Tan,Radius and Tan,Tan,Tan added to the circle tool set would be very useful.
What do you think?
Clive
I haven't seen your request but indeed - that is based on the same idea.
I like to extend the request also for ellipse and arcs. I haven't mention that because I was thinking it is the logistical conclusion ...
Your "start with" sounds good to me but I'm really hoping to get all possibility's to put circle etc. between and added to elements with and (mathematical) without radius.
Husky
Sounds good to me, these potentially added functions would certainly aid my workflow - that's for sure!
Keep up the great ideas.
Die Funktion gibt es nun in QCAD und diese Anfrage könnte geschlossen werden ...