QCAD - 2D CAD System.

Click here for a documentation of the DokuWiki formatting syntax that can be used in reports

Please search for existing tasks (also closed ones) before opening a new task.

Please make sure that you are using the latest Version of QCAD before posting a bug (menu Help > Check for Updates)


FS#633 - Default file type(s) can not be inserted by Visio 2010

Attached to Project: QCAD
Opened by Rich Hagemeyer (richagem) - Tuesday, 19 June 2012, 18:28 GMT+2
Last edited by Andrew (andrew) - Tuesday, 31 July 2012, 11:50 GMT+2
Task Type Bug Report
Category QCAD (main)
Status Closed
Assigned To Andrew (andrew)
Operating System Windows 7
Severity Low
Priority Normal
Reported Version 3 RC5
Due in Version Undecided
Due Date Undecided
Percent Complete 100%
Votes 0
Private No


The R2010 DXF and R2010 DWG formats produced by QCAD 3 RC5 cannot be opened by Visio 2010.

Error message:
Cannot open file. The file may not be a DWG or DXF file, it may not be in a supported version of the DWG file format, or it may be corrupted. Check the file and try again.


  1. QCAD 3 RC5
  2. Visio 2010 with all updates installed

Steps to reproduce:

  1. Open QCAD 3 RC5 and create a basic drawing. Save using the default file types (R2010 DXF or DWG)
  2. Open Visio and create a new drawing.
  3. Go to Insert tab and click CAD Drawing. select drawing created above.
  4. Observe error message

Additional info:

  • When I use Save As in QCAD 3 RC5 and select any previous file format, Visio can insert the drawing. The problem I’m seeing with this part is that on a more complex drawing, the spacing/alignment is messed up (items aren’t in their proper spacing).

Other observations with a more complex file:

  • If I open a R2010 versioned file in Solidworks and then save it back out as a dxf file again, Visio will properly insert the drawing with correct spacing/alignment
  • If I open the file in QCAD and then save as Drawing Exchange (*.DXF) it inserts properly in Visio with correct spacing/alignment.
  • If I open the file in QCAD and then save as Drawing Exchange R12 (*.DXF) it inserts in Visio but the alignment is off (similar to problem above).

File attached for reference.


This task depends upon

Closed by  Andrew (andrew)
Tuesday, 31 July 2012, 11:50 GMT+2
Reason for closing:  Won't fix
Additional comments about closing:  This cannot be fixed on our side (issue between Teigha and Visio)