QCAD Bugtracker

  • Status Closed
  • Percent Complete
    100%
  • Task Type Bug Report
  • Category QCAD (main)
  • Assigned To
    Andrew
  • Operating System Windows 7
  • Severity Low
  • Priority Very Low
  • Reported Version 3 RC5
  • Due in Version Undecided
  • Due Date Undecided
  • Votes
  • Private
Attached to Project: QCAD Bugtracker
Opened by Rich Hagemeyer - 19.06.2012
Last edited by Andrew - 31.07.2012

FS#633 - Default file type(s) can not be inserted by Visio 2010

The R2010 DXF and R2010 DWG formats produced by QCAD 3 RC5 cannot be opened by Visio 2010.

Error message:
Cannot open file. The file may not be a DWG or DXF file, it may not be in a supported version of the DWG file format, or it may be corrupted. Check the file and try again.

Prerequisites:

  1. QCAD 3 RC5
  2. Visio 2010 with all updates installed

Steps to reproduce:

  1. Open QCAD 3 RC5 and create a basic drawing. Save using the default file types (R2010 DXF or DWG)
  2. Open Visio and create a new drawing.
  3. Go to Insert tab and click CAD Drawing. select drawing created above.
  4. Observe error message

Additional info:

  • When I use Save As in QCAD 3 RC5 and select any previous file format, Visio can insert the drawing. The problem I’m seeing with this part is that on a more complex drawing, the spacing/alignment is messed up (items aren’t in their proper spacing).

Other observations with a more complex file:

  • If I open a R2010 versioned file in Solidworks and then save it back out as a dxf file again, Visio will properly insert the drawing with correct spacing/alignment
  • If I open the file in QCAD 2.2.2.0 and then save as Drawing Exchange (*.DXF) it inserts properly in Visio with correct spacing/alignment.
  • If I open the file in QCAD 2.2.2.0 and then save as Drawing Exchange R12 (*.DXF) it inserts in Visio but the alignment is off (similar to problem above).

File attached for reference.

Thanks,
Rich

Closed by  Andrew
31.07.2012 09:50
Reason for closing:  Won't fix
Additional comments about closing:  

This cannot be fixed on our side (issue between Teigha and Visio)

Loading...

Available keyboard shortcuts

Tasklist

Task Details

Task Editing