- Status Closed
- Percent Complete
- Task Type Bug Report
- Category QCAD (main)
-
Assigned To
Andrew - Operating System All
- Severity Low
- Priority Very Low
- Reported Version 3.0.0
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
Attached to Project: QCAD Bugtracker
Opened by Keith Hudson - 08.08.2012
Last edited by Andrew - 17.11.2015
Opened by Keith Hudson - 08.08.2012
Last edited by Andrew - 17.11.2015
FS#666 - When opening a qcad edited or created dwg in autocad, only the first line of text is displayed
When opening a qcad edited or created dwg in autocad, only the first line of text is displayed for each Qcad edited or created text entry.
Qcad 3.0.0 Autocad Mac 2011
You can see that when opening the drawing in Autocad that only the First line of text is present.
Sorry here is the image
Not reproducible here with new drawing, multiline text.
Please attach or e-mail drawing file if possible, thanks.
Hi Andrew,
This file when opened in Autocad 2009 will display only the first line of text centred to the overall text position.
I have seen this with several versions of Autocad. Simmilarly I have had Autocad files open with messed up text in QCAD. PDF of Result included.
Could it be that you are using a release candidate (RC) of QCAD 3 and not the final version?
When I load the drawing in QCAD 3 final, the text is also shown on one line. If I correct the text in QCAD 3 final and save as DWG 2010, it opens fine in Autocad.
Hi Andrew
Sorry for long delay
V 3.0 Should this read 3.0.0 as that is what I installed.
Date Jul 19 2012
QT version 4.7.4
Teigha Version 3.05.0.0
Edition Full Version
No Updates available
Please advise if there is a later version and how to obtain. It is not in my RibbonSoft account.