QCAD Bugtracker

  • Status Assigned
  • Percent Complete
    0%
  • Task Type Feature Request
  • Category QCAD (main)
  • Assigned To
    Andrew
  • Operating System All
  • Severity Low
  • Priority Very Low
  • Reported Version 3.0.0
  • Due in Version Undecided
  • Due Date Undecided
  • Votes 2
  • Private
Attached to Project: QCAD Bugtracker
Opened by Robert L Brush III - 22.10.2012
Last edited by Andrew - 25.10.2012

FS#704 - Old Hatch Function

It would be nice to implement the old hatch function as a tile function in parallel with the newer more industry standard hatch function. A tile function that would allow overlap +/- would be even better, and a great productivity boost, almost like an array within a set of bounds.

Thanks, Bob

24.10.2022 : A task closure has been requested. Reason for request: Hatching hasn't an option 'Use clipboard content as pattern' any longer
Admin
Andrew commented on 28.02.2013 14:56

Pattern fill tool:

Use case:

  1. Select closed contour
  2. Start tool
  3. Dialog:
    • Choose predefined pattern or tick '[ ] Use clipboard content as pattern'
    • Choose pattern parameters
      • margins (negative for overlap)
      • [ ] repeat pattern (uncheck to paste one single copy of the clipboard into a contour and clip at contour borders)

Result:

  • Loose entities or new block with the pattern as contents.
CVH commented on 04.03.2021 13:18

Andrew,
Is this still in the running?
It doesn't look close to what hatching is in 2021.

Loading...

Available keyboard shortcuts

Tasklist

Task Details

Task Editing