QCAD - 2D CAD System.
Please search for existing tasks (also closed ones) before opening a new task.
FS#707 - segmentation fault on every start - after crash
Opened by Klavs Klavsen (klavs) - Wednesday, 24 October 2012, 21:14 GMT+1
Last edited by Andrew (andrew) - Friday, 26 October 2012, 10:55 GMT+1
I was drawing on a drawing done in qcad2 - and now working on it in qcad3 - where I had saved it in the new dxf 2010 format (if this has any relevance) and then the computer ran out of power (old battery - I missed that I hadn’t turned on external power) - and shut down hard.
When I rebooted and tried to start qcad - it crashed on startup - giving only this output:
I then tried removing the entire qcad-3.0.0-prof-linux-alt-x86 folder - and unpackaging the install tar.gz again.
It then started up and came to initializing plugins - 79% - and just hung - I’ve attached screenshot.
After I ctrl+c’ed it - it segfaulted and now it won’t even show the startup splash again.
I’m guessing qcad has saved some state somewhere.. but qcad hasn’t made a ~klavs/.qcad - so I don’t know where it is.
I would very much like to be able to use qcad again :(
Friday, 26 October 2012, 10:55 GMT+1
Reason for closing: Fixed