QCAD Bugtracker

  • Status Closed
  • Percent Complete
    100%
  • Task Type Bug Report
  • Category QCAD (main)
  • Assigned To
    Andrew
  • Operating System All
  • Severity Low
  • Priority Very Low
  • Reported Version Development
  • Due in Version Undecided
  • Due Date Undecided
  • Votes
  • Private
Attached to Project: QCAD Bugtracker
Opened by Christian Aigner - 14.02.2013
Last edited by Andrew - 18.02.2013

FS#765 - Imprecise drawing of circle

I use version 3.0.8

By accident I stumbled across a minor bug.

I wanted to connect two arcs seamlessly with a third arc. (Image 1)

So I drew two straight lines at right angles at the end of each arc, and at the crossing I put the center point of a circle. (Image 2)

Out of curiosity I zoomed in to the end of the second arc and discovered that the circle did not go through the end point of the arc, even tough I snapped it to the end point. (Image 3)

I could trim the circle to the wanted arc and the arc is displayed without any displacement.

So it seems that only the display of the circle is faulty, not the internal representation of it.

Closed by  Andrew
18.02.2013 16:59
Reason for closing:  Fixed
Additional comments about closing:  

Caused by new approximation of arcs with splines. New implementation reverts back to line segments.

Christian Aigner commented on 15.02.2013 06:22

Oh, I forgot to mention that I use the Linux version. Sorry.

-- commented on 18.02.2013 10:50

Testing 3.0.8
Windows 7 - 64
I can reproduce this also.

Loading...

Available keyboard shortcuts

Tasklist

Task Details

Task Editing