QCAD Bugtracker

  • Status Closed
  • Percent Complete
    100%
  • Task Type Bug Report
  • Category QCAD (main)
  • Assigned To
    Andrew
  • Operating System Windows (All)
  • Severity Low
  • Priority Very Low
  • Reported Version Development
  • Due in Version Undecided
  • Due Date Undecided
  • Votes
  • Private
Attached to Project: QCAD Bugtracker
Opened by -- - 12.03.2013
Last edited by Andrew - 16.12.2013

FS#785 - Hatch at scale 1/10 not completed on 500 mm x 500 mm square?

Windows 7-64
3.0.8

I’ve not been able to hatch a simple Brick pattern at a scale of 1/10 on anything larger that 500 mm x 500 mm.

*Scale of 1:1 works fine
*Scale of 1/10 works fine on Squares 400 mm x 400 mm or less!

To reproduce:
1. Draw square of 500 x 500 mm.
2. Select and execute Hatch command using Brick pattern (but I suspect the result will be the same with any pattern).
3. Result in selection states a Hatch but no hatch is present!

Please see attached image:

Closed by  Andrew
16.12.2013 12:52
Reason for closing:  Won't fix
-- commented on 12.03.2013 19:10

Edit: Should read scale 1/20, but I have noticed that on some larger areas a scale of 1/10 is not working either!

Is there a limit in the size area for using hatches in general in QCAD?

Admin
Andrew commented on 12.03.2013 19:36

There is a timeout of 5 seconds for generating a hatch. This is to make sure the program does not freeze for hours if the user enters for example a factor of 0.0001.
The timeout can only be adjusted by editing the QCAD configuration file directly at this point. In section 'GraphicsView', add a value for MaxHatchTime, for example for a timeout of one minute (= 60 seconds = 60000 milliseconds):

[GraphicsView]
MaxHatchTime = 60000

The configuration file is called QCAD3.ini or QCAD3.conf and under Windows located under C:\Users\username\AppData\Roaming\RibbonSoft\

-- commented on 12.03.2013 20:01

Great, thanks Andrew, that's got it ! Useful tip to know.

Loading...

Available keyboard shortcuts

Tasklist

Task Details

Task Editing