QCAD

QCAD - 2D CAD System.

Click here for a documentation of the DokuWiki formatting syntax that can be used in reports

Please search for existing tasks (also closed ones) before opening a new task.

Please make sure that you are using the latest Version of QCAD before posting a bug (menu Help - Check for Updates)

Tasklist

FS#843 - Can't snap to reference point of a block reference

Attached to Project: QCAD
Opened by Husky (Husky) - Thursday, 27 June 2013, 04:31 GMT+1
Last edited by Andrew (andrew) - Thursday, 27 June 2013, 20:09 GMT+1
Task Type Bug Report
Category Main
Status Closed
Assigned To Andrew (andrew)
Operating System All
Severity Low
Priority Normal
Reported Version 3.1.2
Due in Version Undecided
Due Date Undecided
Percent Complete 100%
Votes 0
Private No

Details

If I need to move etc. a block regarding to his reference point - I’m not able to snap to the reference point :-( All other snap points are appear as just fine working ...

This task depends upon

Closed by  Andrew (andrew)
Thursday, 27 June 2013, 20:09 GMT+1
Reason for closing:  Fixed
Comment by -- (clive) - Thursday, 27 June 2013, 11:06 GMT+1

With a simple test, for me all is working OK.

Are you able to attach a sample for testing ?

Comment by Husky (Husky) - Thursday, 27 June 2013, 19:28 GMT+1

Sure: Try to move the block in this drawing and snap to the block reference (located in the right lower triangle area)

Comment by -- (clive) - Thursday, 27 June 2013, 19:52 GMT+1

Thanks, yes absolutely you are correct.

My simple test used a reference point on an easy intersection point.

I've just re-tested this using a reference point not on an end point or intersection etc.. and I get the same results, so I agree, this is a bug!

Comment by Andrew (andrew) - Thursday, 27 June 2013, 20:09 GMT+1

There's a bit of a dilemma here:
Previously, QCAD used to snap to the one reference point of a block reference when snapping ro reference points.
A bug was filed since users expected it to snap to reference points inside the block reference instead (e.g. the reference points of a circle that is part of the block).
So the behavior was changed.
Now it was changed again: future QCAD versions will snap to both internal reference points and the reference point of the block.

Comment by -- (clive) - Thursday, 27 June 2013, 20:33 GMT+1

Great, sounds good ;)

Comment by Husky (Husky) - Thursday, 27 June 2013, 21:05 GMT+1

Yep, sounds also good to me! ;-)

Loading...