- Status Assigned
- Percent Complete
- Task Type Feature Request
- Category QCAD (main)
-
Assigned To
Andrew Benjamin Dahl - Operating System All
- Severity Low
- Priority Very Low
- Reported Version 3.1.4
- Due in Version Undecided
-
Due Date
Undecided
-
Votes
1
- Benjamin Dahl (23.10.2013)
- Private
Attached to Project: QCAD Bugtracker
Opened by Benjamin Dahl - 05.07.2013
Last edited by Andrew - 05.07.2013
Opened by Benjamin Dahl - 05.07.2013
Last edited by Andrew - 05.07.2013
FS#849 - Make maximum visible reference points of selection configurable
Provide configuration option to raise / lower maximum reference points that are shown for selected entities (currently fixed to 1000).
Original report:
Imported a spline-dxf from adobe illustrator. Converted the spline to polyline with explode command. Then no anchor points / vertex points / vertices were showing anymore. Simplified the polyline so that it had less than 1000 points. Vertices became visible.
I think some freeform objects need actually more than 1000 vertices. Also them need to be edited. Please increase the amount of vertices showing to biginteger
regards
Benjamin
This is a limit imposed by display performance, not data type.
I'll change this into a feature request to make this limit configurable.