QCAD Bugtracker

  • Status Assigned
  • Percent Complete
    0%
  • Task Type Feature Request
  • Category QCAD (main)
  • Assigned To
    Andrew
    Benjamin Dahl
  • Operating System All
  • Severity Low
  • Priority Very Low
  • Reported Version 3.1.4
  • Due in Version Undecided
  • Due Date Undecided
  • Votes 1
  • Private
Attached to Project: QCAD Bugtracker
Opened by Benjamin Dahl - 05.07.2013
Last edited by Andrew - 05.07.2013

FS#849 - Make maximum visible reference points of selection configurable

Provide configuration option to raise / lower maximum reference points that are shown for selected entities (currently fixed to 1000).

Original report:

Imported a spline-dxf from adobe illustrator. Converted the spline to polyline with explode command. Then no anchor points / vertex points / vertices were showing anymore. Simplified the polyline so that it had less than 1000 points. Vertices became visible.

I think some freeform objects need actually more than 1000 vertices. Also them need to be edited. Please increase the amount of vertices showing to biginteger

regards

Benjamin

25.10.2022 : A task closure has been requested. Reason for request: Implemented
Admin
Andrew commented on 05.07.2013 17:38

This is a limit imposed by display performance, not data type.

I'll change this into a feature request to make this limit configurable.

Loading...

Available keyboard shortcuts

Tasklist

Task Details

Task Editing