QCAD Bugtracker

  • Status Assigned
  • Percent Complete
    0%
  • Task Type Feature Request
  • Category QCAD (main)
  • Assigned To
    Andrew
    Benjamin Dahl
  • Operating System All
  • Severity Low
  • Priority Very Low
  • Reported Version 3.1.4
  • Due in Version Undecided
  • Due Date Undecided
  • Votes 1
  • Private
Attached to Project: QCAD Bugtracker
Opened by Benjamin Dahl - 05.07.2013
Last edited by Andrew - 05.07.2013

FS#849 - Make maximum visible reference points of selection configurable

Provide configuration option to raise / lower maximum reference points that are shown for selected entities (currently fixed to 1000).

Original report:

Imported a spline-dxf from adobe illustrator. Converted the spline to polyline with explode command. Then no anchor points / vertex points / vertices were showing anymore. Simplified the polyline so that it had less than 1000 points. Vertices became visible.

I think some freeform objects need actually more than 1000 vertices. Also them need to be edited. Please increase the amount of vertices showing to biginteger

regards

Benjamin

Admin
Andrew commented on 05.07.2013 17:38

This is a limit imposed by display performance, not data type.

I'll change this into a feature request to make this limit configurable.

Loading...

Available keyboard shortcuts

Tasklist

Task Details

Task Editing