- Status Closed
- Percent Complete
- Task Type Bug Report
- Category QCAD (main)
-
Assigned To
Andrew - Operating System Windows (All)
- Severity Medium
- Priority Very Low
- Reported Version 3.3.2
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
Attached to Project: QCAD Bugtracker
Opened by Eric Duguay - 16.10.2013
Last edited by Andrew - 22.10.2013
Opened by Eric Duguay - 16.10.2013
Last edited by Andrew - 22.10.2013
FS#943 - Dashed lines with line weight 0 are displayed as continuous when drawing unit is meters
When we create a draft in version 2.2.2 we put dashed lines and the length is 0. We see a dash lines. (see attach file).
When we open the same draft in the version 3.3.2 we don’t see the dashed lines we see a continous lines.
If I changed in the dxf this lines DASHED 370 0 per DASHED 370 5 and changes the preference of the drawing it’s work.
But we don’t want to open all of 180000 drawings to change the length of the dashed lines from 0 to 5. We want that the version 3 print the dashed lines as the version 2.
Thanks
Eric
bug qcad.docx
(76.3 KiB)
Closed by Andrew
22.10.2013 19:56
Reason for closing: Fixed
Additional comments about closing:
22.10.2013 19:56
Reason for closing: Fixed
Additional comments about closing:
Implemented preferences and viewing
options to configure behavior with 0.00
width lines and line patterns in model
space.
Thanks for your report.
I'm working on an application preference to adjust these behaviors.