- Status Assigned
- Percent Complete
- Task Type Feature Request
- Category QCAD (main)
-
Assigned To
Andrew - Operating System All
- Severity Low
- Priority Very Low
- Reported Version 3.4.0
- Due in Version Undecided
-
Due Date
Undecided
-
Votes
3
- CVH (30.10.2022)
- Jean-Jacques Brasse (02.06.2014)
- Husky (24.10.2013)
- Private
Attached to Project: QCAD Bugtracker
Opened by Tamas TEVESZ - 24.10.2013
Last edited by Andrew - 21.09.2016
Opened by Tamas TEVESZ - 24.10.2013
Last edited by Andrew - 21.09.2016
FS#952 - Dimensions: manually control arrow position
See drawing: I can’t seem to be able to manually change to the “To” variants – that is, override the decision of the label/arrow placement engine.
The circle in the attachment is a borderline example of when even just in this form I would more like it on the outside. If the drawing is crowded in that area, it would be even more useful to have it the other way around.
For the upper example one can flip the arrow.
This doesn't work for the lower example.
But this is certainly not the only request to support more Styles.
Regards,
CVH