- Status Closed
- Percent Complete
- Task Type Bug Report
- Category QCAD (main)
-
Assigned To
Andrew - Operating System All
- Severity Low
- Priority Very Low
- Reported Version 3.4.2
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
Attached to Project: QCAD Bugtracker
Opened by Anonymous Submitter - 19.11.2013
Last edited by Andrew - 19.11.2013
Opened by Anonymous Submitter - 19.11.2013
Last edited by Andrew - 19.11.2013
FS#974 - Trim not working for Chamfer/Bevel or Round tools
Trim not working for Chamfer/Bevel or Round tools in 3.4.3.
With Trim checked nothing happens.
I cannot reproduce this problem here.
Can you verify this with a new drawing, draw a rectangle, round / bevel?
Could it be that you are on a locked or invisible layer (just a thought...)?
Thanks.
Ha, locked layer. So not a bug...just keeping you on your toes :)
OK, thanks :)