- Status Closed
- Percent Complete
- Task Type Bug Report
- Category QCAD (main)
-
Assigned To
Andrew - Operating System Windows 7
- Severity Low
- Priority Very Low
- Reported Version 3.4.4
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
Attached to Project: QCAD Bugtracker
Opened by Anonymous Submitter - 06.12.2013
Last edited by Andrew - 17.11.2015
Opened by Anonymous Submitter - 06.12.2013
Last edited by Andrew - 17.11.2015
FS#988 - Hatching in ISO projection gives unwanted result
Not sure whether this has been reported yet.
I get an unexpected result when creating a solid fill hatch in an isometric projection, all entities are polylines.
I am aware that the hatch tool fails in 'some' situations, usually if shapes are rather complex with ellipses and/or splines (such as exploded or projected texts).
I'm relying on Qt for this functionality, so it's unlikely that this problem can be fixed on the QCAD side.
As a workaround it sometimes helps to break down the shape into several, smaller shapes. In the case of exploded or projected texts, use the hatch tool on one or a few individual letters at once instead of the whole text.
Okay thank you Andrew for spending your time to look at this for me, much appreciated. I will take your advice and try to break things down a little and see how that goes.
Thanks again.
Okay, I split the drawing into four and successfully projected and hatched it ;). So yes it is doable -but takes a little time.