QCAD Bugtracker

  • Status Closed
  • Percent Complete
  • Task Type Bug Report
  • Category QCAD (main)
  • Assigned To
  • Operating System Windows 7
  • Severity Low
  • Priority Very Low
  • Reported Version 3.4.4
  • Due in Version Undecided
  • Due Date Undecided
  • Votes
  • Private
Attached to Project: QCAD Bugtracker
Opened by -- - 06.12.2013
Last edited by Andrew - 17.11.2015

FS#988 - Hatching in ISO projection gives unwanted result

Not sure whether this has been reported yet.
I get an unexpected result when creating a solid fill hatch in an isometric projection, all entities are polylines.

Closed by  Andrew
17.11.2015 09:26
Reason for closing:  Won't fix
Andrew commented on 06.12.2013 18:56

I am aware that the hatch tool fails in 'some' situations, usually if shapes are rather complex with ellipses and/or splines (such as exploded or projected texts).
I'm relying on Qt for this functionality, so it's unlikely that this problem can be fixed on the QCAD side.
As a workaround it sometimes helps to break down the shape into several, smaller shapes. In the case of exploded or projected texts, use the hatch tool on one or a few individual letters at once instead of the whole text.

-- commented on 06.12.2013 20:38

Okay thank you Andrew for spending your time to look at this for me, much appreciated. I will take your advice and try to break things down a little and see how that goes.

Thanks again.

-- commented on 09.12.2013 13:48

Okay, I split the drawing into four and successfully projected and hatched it ;). So yes it is doable -but takes a little time.


Available keyboard shortcuts


Task Details

Task Editing